|
Sub-Structural Components
Standard Punching Patterns - Cees & Zees


- All Cees are manufactured with symmetrical flanges.
- Cees
and Zees are manufactured in accordance with LGSI requirements.
For code requirements, contact Sawyer’s Customer
Service Department or Sales Representative.
- Flange
punching is available on 6” through
12” Zees and Cees,
but must be requested.
- Web punching is available on
6” through 12” Zees
and Cees.
For web punching on 4” members, contact Sawyer’s
Customer
Service Department or Sales Representative.
- Limited
web and flange holes may be added. A drawing must
accompany the order.
- Zees and Cees may have extra holes
- these are used for alternate
bolting patterns.
- Sag rod holes, when requested, are located at
the center of the Cee or Zee length, and at the center
of the section depth. A drawing must accompany orders
for other hole locations.
- For lengths less than 8’ that
require punching, contact Sawyer’s
Customer Service Department.
- Round holes are 5/8” diameter,
slots are 5/8” x
3/4”.
- Holes are punched to accommodate 1/2” diameter
bolts.
- For questions regarding orders or product information,
contact
Sawyer’s Customer Service Department or Sales
Representative.
- Consult LGSI Manual for design information.
|